Sorry to be direct, but can any-one help me with the location of the vacuum hoses that work the heater unit, perhap even photos etc. I would really appreciate it.
Thanks martinH
First the layout.
The direction of airflow from the heater is done by moveable flaps powered by vacuum servos. The vacuum is supplied by a hose that feeds through the bulkhead adjacent to the water pipes that feed the heater, ie just below/beside the brake reservoir. On most models, this vacuum comes via a small tank/reservoir tucked in the opposite corner, in the box with the pollen filter. I believe some specs did not have this tank.
However, if you can change from screen to face to feet back to screen etc (engine must be running or vac reervoir is quickly drained) then you are getting vacuum to the heater.
That is as far as my knowledge goes, however my experience is much the same as yours - the output from the feet and face is strong but the screen vent is poor in comparison to other cars I have had. Doubt it would lift a sheet of A4 paper even on max fan.
I just put it down to the wide diffuser removing all the power even though there is still a large volume of air.
Maybe someone else can offer more help on that.
Steve