Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: v6 cambelt  (Read 413 times)

0 Members and 1 Guest are viewing this topic.

stewie

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 4
    • View Profile
v6 cambelt
« on: 28 April 2011, 12:58:44 »
hi,started today doing cambelt change on my 2.6 mv6,all stripped down, 3 and 4 bank locking tool slots in fine, 1 and 2 doesnt,timing way advanced (last done at vaux dealer)!,how do i move it back to fit the tool,looked at dvd but only shows retarded timing advanced by centre tensioner to fit tool, :-/
Logged

TheBoy

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 106838
  • I Like Lockdown
    • Whatever Starts
    • View Profile
Re: v6 cambelt
« Reply #1 on: 28 April 2011, 13:05:48 »
use similar method to timing new belt - if its more than a tooth out, crank needs to go to 60 degrees btdc, the belt removed, cams locked at correct position (using marking on backplate), then move crank back to tdc...
Logged
Grumpy old man

stewie

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 4
    • View Profile
Re: v6 cambelt
« Reply #2 on: 28 April 2011, 13:13:04 »
thanks, thought that would be the thing to do just wanted to be sure,done many cars never a v6, :y
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.016 seconds with 17 queries.