Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Pages: [1]   Go Down

Author Topic: EML light on, lots of codes after cat change.  (Read 891 times)

0 Members and 1 Guest are viewing this topic.

geoffr70

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Sunderland
  • Posts: 2665
  • Boobies
    • F/L 3.0 Elite, 3.0 MV6
    • View Profile
EML light on, lots of codes after cat change.
« on: 09 June 2011, 20:47:19 »
Hello all. Changed the cats and lambda sensors on a 2000 (w) 3.0 v6 for aftermarket ones that were a few weeks old. I took out the fuse (29b), the big red 50 amp one, and capped off the SAI. I started the engine and let it tick over till the choke turned off, then manoeuvred it on the drive. It was driven later, when after 15 mins the eml started to flash so quickly it's more or less on permanently, and these codes showed up:

13, O2 sensor 1 open circuit. 31, No engine RPM signal. 48, Battery Voltage Low. 57, Idle air control voltage low, 73, Mass air flow sensor voltage low. 144, Immobiliser no signal. 145, Immobiliser wrong signal.

Any ideas about that anyone? I can't see why all apart from O2 sensor would show up, but you never know. Thanks
Logged
TC and BnQ Trade holder.
I'll out pull you with my caravan!
V6 locking kit available locally, with deposit.

Lazydocker

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Woodbridge, Suffolk
  • Posts: 18848
  • Constantly Bullied by a certain Admin
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #1 on: 09 June 2011, 21:06:09 »
That's interesting... Exactly the same problems as in this thread!

Same situation, same problems... Or is it the same car?
Logged
Whatever it is... I didn't do it

RobG

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Bristol
  • Posts: 13831
  • I might have a link, pic or part number for that
    • 16 plate Mokka. Vivaro
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #2 on: 09 June 2011, 21:11:34 »
Quote
That's interesting... Exactly the same problems as in this thread!

Same situation, same problems... Or is it the same car?
Think it`s the same car Paul. Another member (not OP) agreed to buy my GM cats. http://www.omegaowners.com/forum/YaBB.pl?num=1307206754
Thread was hijacked then I get a message following day saying it wasn`t the cats but a loose heatshield >:( >:( >:(
Logged
All that is necessary for the triumph of evil is that good men do nothing.

UPVC windows/doors/fascias/soffit/gutters supplied/fitted

geoffr70

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Sunderland
  • Posts: 2665
  • Boobies
    • F/L 3.0 Elite, 3.0 MV6
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #3 on: 09 June 2011, 21:13:30 »
Quote
That's interesting... Exactly the same problems as in this thread!

Same situation, same problems... Or is it the same car?

Yes!
Logged
TC and BnQ Trade holder.
I'll out pull you with my caravan!
V6 locking kit available locally, with deposit.

geoffr70

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Sunderland
  • Posts: 2665
  • Boobies
    • F/L 3.0 Elite, 3.0 MV6
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #4 on: 09 June 2011, 21:15:02 »
Quote
Quote
That's interesting... Exactly the same problems as in this thread!

Same situation, same problems... Or is it the same car?
Think it`s the same car Paul. Another member (not OP) agreed to buy my GM cats. http://www.omegaowners.com/forum/YaBB.pl?num=1307206754
Thread was hijacked then I get a message following day saying it wasn`t the cats but a loose heatshield >:( >:( >:(

Wouldn't say I hijaced it tbh. Just giving him a wider range of options
Logged
TC and BnQ Trade holder.
I'll out pull you with my caravan!
V6 locking kit available locally, with deposit.

Lazydocker

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Woodbridge, Suffolk
  • Posts: 18848
  • Constantly Bullied by a certain Admin
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #5 on: 09 June 2011, 21:15:09 »
Quote
Quote
That's interesting... Exactly the same problems as in this thread!

Same situation, same problems... Or is it the same car?

Yes!

Ahhh... Duplicate thread. That explains it. I was thinking it was a huge coincidence for a minute and related to poor quality cats ;) ;)
Logged
Whatever it is... I didn't do it

Jimbob

  • Global Moderator
  • *****
  • Offline Offline
  • Gender: Male
  • Chester / Flintshire
  • Posts: 24539
  • I like traffic lights, but only when they're green
    • E250 Est / Golf GTI
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #6 on: 09 June 2011, 21:48:22 »
locking this as duplicate then
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34072
  • Git!
    • View Profile
Re: EML light on, lots of codes after cat change.
« Reply #7 on: 10 June 2011, 10:13:32 »
I wouldn't say this is the same thread at all.

One is talking about blocked cats and the blowing of secondary air injection pipes and the other about a pile of fault codes which have appeared after changing cats (note, check battery voltage!)
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.012 seconds with 17 queries.