Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Crankshaft sensor failed. Where does it plug in?  (Read 785 times)

0 Members and 1 Guest are viewing this topic.

Captain Slower

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Reading, Berkshire
  • Posts: 31
    • View Profile
Crankshaft sensor failed. Where does it plug in?
« on: 02 July 2011, 14:28:53 »
Afternoon gents, I need some urgent advice please.
My crankshaft sensor failed yesterday. Mangaed to get the car home and have purchased hopefully the correct part. I can see where it is fixed at the bottom of the engine, but cannot find the plug at the top. I believe it should be somewhere around the HBV. Can anyone give me a more precise pointer.
Much appreciated in advance.
« Last Edit: 02 July 2011, 14:38:15 by TonyEd »
Logged

Osprey

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Redhill, Surrey
  • Posts: 677
  • Drink up. The world's about to end.
    • 01 2.6 Elite saloon
    • View Profile
Re: Crankshaft sensor failed. Where does it plug in?
« Reply #1 on: 02 July 2011, 14:48:42 »
Piccies here:

http://www.omegaowners.com/forum/YaBB.pl?num=1174321688

Engine removed for clarity and ease of access  ;)
Logged
I feel like a military academy. Bits of me keep passing out.

fiend61

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • york
  • Posts: 1544
  • each to their own
    • 2.5cdx 3.0mv6 3.2vec c
    • View Profile
Re: Crankshaft sensor failed. Where does it plug in?
« Reply #2 on: 02 July 2011, 17:15:51 »
its on the otherside to ther hbv rear right of engine as you look in engine bay, if never been changed before will be clipped to back of engine, there is also a big black  multiplug in the same place so if you find that the cranksensor plug is not too far away  :y
Logged

Captain Slower

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Reading, Berkshire
  • Posts: 31
    • View Profile
Re: Crankshaft sensor failed. Where does it plug in?
« Reply #3 on: 02 July 2011, 19:35:14 »
Thanks sooooo much for the posts :y. Routing the new cable was fun or not >:(, depending on patience levels. It all seems to be working ok for now, took the old girl on a test drive to Bracknell and back, all seems good. 8-)

saved the page with the photo, just in case.

Cheers
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.012 seconds with 18 queries.