Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Multi ram question  (Read 1038 times)

0 Members and 1 Guest are viewing this topic.

lou

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Romford
  • Posts: 178
  • Always expect the unexpected
    • View Profile
Multi ram question
« on: 25 June 2011, 17:44:23 »
Just been out doing the usual checks. When I blip the throttle the back actuator does not move but the front is moving at a certain speed. Checked all connection and Vac and all seems normal. Should the back one change when reved? All seems ok when driving and have not notice any changes.
Logged

bigegg

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Leeds
  • Posts: 1218
    • MV6 RIP - Lexus GS300 '99
    • View Profile
Re: Multi ram question
« Reply #1 on: 25 June 2011, 18:22:14 »
Mine is exactly the same - not sure if that's what it's supposed to do, as it may only activate "under load" rather than just a certain engine speed
Logged
Carpe Incendium

Jimbob

  • Global Moderator
  • *****
  • Offline Offline
  • Gender: Male
  • Chester / Flintshire
  • Posts: 24515
  • I like traffic lights, but only when they're green
    • E250 Est / Golf GTI
    • View Profile
Re: Multi ram question
« Reply #2 on: 25 June 2011, 18:31:31 »
yes, they will both moved when revved (at different times)

good hard blip to full power should do it  :y
Logged

feeutfo

  • Guest
Re: Multi ram question
« Reply #3 on: 26 June 2011, 01:26:24 »
Need to be quite violent with the blipping to get the rear one to move ime.

Or get tech2 to test it remotely.
Logged

lou

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Romford
  • Posts: 178
  • Always expect the unexpected
    • View Profile
Re: Multi ram question
« Reply #4 on: 26 June 2011, 12:33:56 »
Perhaps I was too gentle with the throttle as i did not rev the guts out of it. I will give it a go......
Logged

Aivaras

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 12
    • View Profile
Re: Multi ram question
« Reply #5 on: 26 July 2011, 09:06:01 »
hallo to all.

the multi ram valve on the back of inlet manifold should open on 4100rpm, while other one near radiator opens on 3500rpm.
i have a problem with that on the inlet manifold, it shows no signs of working. it shoud work on idle speed and on 4100rpm as i said. the valve is working when i take off The throttle position sesnor (TPS) and i turn it with my finger, then valve opens, but when i put it back on throttle body, valve is not working again.. could someone explain that strange situation? please help.
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.014 seconds with 17 queries.