Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: [1] 2  All   Go Down

Author Topic: Seat swap problem  (Read 2733 times)

0 Members and 1 Guest are viewing this topic.

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Seat swap problem
« on: 21 October 2009, 13:31:36 »
I have swapped my seats for a leather set,followed the wiring instructions Perfect they work as they should.My problem is  when i turn the ignition on the airbag light comes on then goes out as it should but within 3 seconds it comes back on and stays on.Anyone any ideas what the problem is and how do i reset the warning light. 
Logged

Jimbob

  • Global Moderator
  • *****
  • Offline Offline
  • Gender: Male
  • Chester / Flintshire
  • Posts: 24539
  • I like traffic lights, but only when they're green
    • E250 Est / Golf GTI
    • View Profile
Re: Seat swap problem
« Reply #1 on: 21 October 2009, 13:41:16 »
you will need a diag computer to turn the light off.

the same kit will reveal why  it is / was a problem.
Logged

cruisetopoland

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • UK
  • Posts: 1290
    • View Profile
Re: Seat swap problem
« Reply #2 on: 21 October 2009, 15:02:24 »
Likely this could have been avoided if you disconnected battery first to avoid the sensor noting a side 'bag "issue"!

Damn....
Logged

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Re: Seat swap problem
« Reply #3 on: 21 October 2009, 15:48:34 »
i did disconnect the battery but like a idiot didn't move the cable far and it touched the battery .
So could this have given the senser a faulty reading ?  
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34067
  • Git!
    • View Profile
Re: Seat swap problem
« Reply #4 on: 21 October 2009, 15:53:39 »
Quote
i did disconnect the battery but like a idiot didn't move the cable far and it touched the battery .
So could this have given the senser a faulty reading ?  


The airbag ECU would have seen an open circuit on the pre-tensioners and side airbags and hence stored a fault code.

Because its a safety device, the light remains on even if the fault has been sorted.
Logged

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Re: Seat swap problem
« Reply #5 on: 21 October 2009, 16:16:17 »
Quote
Quote
i did disconnect the battery but like a idiot didn't move the cable far and it touched the battery .
So could this have given the senser a faulty reading ?  


The airbag ECU would have seen an open circuit on the pre-tensioners and side airbags and hence stored a fault code.

Because its a safety device, the light remains on even if the fault has been sorted.

My garage has quoted £20 incl to clear fault.does this sound about the right price to pay
« Last Edit: 21 October 2009, 16:16:34 by Selseybill »
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39843
    • ML350 TDM SmartRoadster
    • View Profile
Re: Seat swap problem
« Reply #6 on: 21 October 2009, 16:25:25 »
Quote
Quote
Quote
i did disconnect the battery but like a idiot didn't move the cable far and it touched the battery .
So could this have given the senser a faulty reading ?  


The airbag ECU would have seen an open circuit on the pre-tensioners and side airbags and hence stored a fault code.

Because its a safety device, the light remains on even if the fault has been sorted.

My garage has quoted £20 incl to clear fault.does this sound about the right price to pay

Cheaper than the dealers .... £20 will get it turned off at your garage, but £20odd will buy you a 'Cheapo TechII' forever & will turn your air bag light off as many times as you want.  ;)  ;)
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34067
  • Git!
    • View Profile
Re: Seat swap problem
« Reply #7 on: 21 October 2009, 16:29:06 »
This is worth a punt

http://cgi.ebay.co.uk/"My Naff Code Reader"-090714-v1-39-LATEST-2009-DIAGNOSTICS-VAUX-OPEL_W0QQitemZ300358948066QQcmdZViewItemQQptZUK_Diagnostic_Tools_Equipment?hash=item45eec9d4e2
Logged

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Re: Seat swap problem
« Reply #8 on: 21 October 2009, 17:36:03 »
Quote
Quote
Quote
Quote
i did disconnect the battery but like a idiot didn't move the cable far and it touched the battery .
So could this have given the senser a faulty reading ?  


The airbag ECU would have seen an open circuit on the pre-tensioners and side airbags and hence stored a fault code.

Because its a safety device, the light remains on even if the fault has been sorted.

My garage has quoted £20 incl to clear fault.does this sound about the right price to pay

Cheaper than the dealers .... £20 will get it turned off at your garage, but £20odd will buy you a 'Cheapo TechII' forever & will turn your air bag light off as many times as you want.  ;)  ;)

What do you do with it ? just pug in ?.Never trained on electrics only on engines,running gear etc.Bentley had the men in white overalls to do this stuff.
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39843
    • ML350 TDM SmartRoadster
    • View Profile
Re: Seat swap problem
« Reply #9 on: 21 October 2009, 18:30:35 »
Quote
Quote
Quote
Quote
Quote
i did disconnect the battery but like a idiot didn't move the cable far and it touched the battery .
So could this have given the senser a faulty reading ?  


The airbag ECU would have seen an open circuit on the pre-tensioners and side airbags and hence stored a fault code.

Because its a safety device, the light remains on even if the fault has been sorted.

My garage has quoted £20 incl to clear fault.does this sound about the right price to pay

Cheaper than the dealers .... £20 will get it turned off at your garage, but £20odd will buy you a 'Cheapo TechII' forever & will turn your air bag light off as many times as you want.  ;)  ;)

What do you do with it ? just pug in ?.Never trained on electrics only on engines,running gear etc.Bentley had the men in white overalls to do this stuff.

In a nut shell .... yes!  ;) You plug one end into the diagnostic socket under the dash and the other end to your laptop via the lead. Install the program & you're away! I don't do computer etc either but can manage my simpler version. ;)  ;)  :y  :y
Logged

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Re: Seat swap problem
« Reply #10 on: 21 October 2009, 23:14:05 »
By using this as a complete computer idiot can i balls anything up 
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39843
    • ML350 TDM SmartRoadster
    • View Profile
Re: Seat swap problem
« Reply #11 on: 21 October 2009, 23:24:35 »
Quote
By using this as a complete computer idiot can i balls anything up 

I wouldn't like to say!!!!! I suppose anything's possible.  ;D  ;D  ;D  ;D Mine's only very basic, ie read fault codes & can reset airbag lights, so I reckon it's nigh on impossible. Can't say about the "My Naff Code Reader" though.
Logged

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Re: Seat swap problem
« Reply #12 on: 21 October 2009, 23:36:32 »
Quote
Quote
By using this as a complete computer idiot can i balls anything up 

I wouldn't like to say!!!!! I suppose anything's possible.  ;D  ;D  ;D  ;D Mine's only very basic, ie read fault codes & can reset airbag lights, so I reckon it's nigh on impossible. Can't say about the "My Naff Code Reader" though.


Read some where on here "My Naff Code Reader" can cause more trouble than it's worth.but i may have read wrong
Logged

Selseybill

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • La Rochelle
  • Posts: 702
    • 2.0 pre face, 2.2 CDX est
    • View Profile
Re: Seat swap problem
« Reply #13 on: 21 October 2009, 23:45:30 »
Coming back from the lodge tonight i found out i can set up the memory on the seats but i was lead to believe without plugging in the large multi plug(which i  have no wiring to the car for)this wouldn't work.Have i wired something up wrong ?
Logged

CaptainZok

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Bolton
  • Posts: 8093
  • Victim of Cyberbullying.
    • 3.2 MV6 Estate
    • View Profile
Re: Seat swap problem
« Reply #14 on: 22 October 2009, 00:47:08 »
"My Naff Code Reader" makes a decent code reader but is a bit dodgy at programming radios or keys.
So if you stick to reading codes or collecting live data from the car you should be fine.
Logged
PM me for code reading/clearing
TuBy's new whipping boy.
Pages: [1] 2  All   Go Up
« previous next »
 

Page created in 0.023 seconds with 17 queries.