Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - cnc-dude

Pages: [1]
1
Omega General Help / Re: ignition on syl 2 and 3 only
« on: 13 January 2009, 22:51:21 »
The spark plugs are new.

There are three wires to the dis module. I believe one is signal for syl 1&4, one for 2&3 and the last one is ground.

I think I'm missing a signal from the ecu. I've measured the signal from the ecu when the engine is running (on 2&3), but I was not able to recognise any problems with a voltmeter. must probably have an oscilloscope.

Is the crankshaft and camshaft sensors the only input sensors that controls the ecu's ignition output?

2
Omega General Help / Re: ignition on syl 2 and 3 only
« on: 13 January 2009, 22:12:43 »
No, thank's for the tip. I was suspecting a ecu fault, so I tried another. I could not start the car because of the "start security device" (dont kow the english word). But I had sparks on 2&3 with this one as well. The dis unit is new.

3
Omega General Help / Re: ignition on syl 2 and 3 only
« on: 13 January 2009, 21:57:45 »
I'm checking the spark. new leads. I've not checked the resistans in the cables, but i've cross swiched them.

4
Omega General Help / Re: ignition on syl 2 and 3 only
« on: 13 January 2009, 21:52:35 »
I have ohm'd the cables to the ecu, they are ok.

5
Omega General Help / Re: ignition on syl 2 and 3 only
« on: 13 January 2009, 21:50:54 »
Thank's for quick reply. I can start the engine on the two sylinders. The light on the engine lamp goes off when the engine starts. History fault codes are 19 and 92.

6
Omega General Help / Re: ignition on syl 2 and 3 only
« on: 13 January 2009, 21:45:41 »
I have replaced the dis module with a new one. Problem remains....

7
Omega General Help / ignition on syl 2 and 3 only
« on: 13 January 2009, 21:40:02 »
I'm missing ignition on syl 1 and 4. Any ideas? Engine x20xev.

Pages: [1]

Page created in 0.008 seconds with 14 queries.