Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1] 2 3  All   Go Down

Author Topic: Urgent help needed! Won't start  (Read 3025 times)

0 Members and 2 Guests are viewing this topic.

richardirv

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Leeds, West Yorkshire
  • Posts: 1359
    • Omega 2.6 MV6 2002
    • View Profile
Urgent help needed! Won't start
« on: 24 October 2010, 10:32:33 »
Hi all, really need your help chaps, car not missed a beat and went to start it last night and it won't start. All I hear is the starter, engine is not attempting to start at all. A friend said it was starter motor clutch but the looked and found that the aux belt is turning so probably not the starter.

Need help and possibly someone to fix it.

Thank in advance.
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39729
    • ML350 TDM SmartRoadster
    • View Profile
Re: Urgent help needed! Won't start
« Reply #1 on: 24 October 2010, 10:36:52 »
Quote
Hi all, really need your help chaps, car not missed a beat and went to start it last night and it won't start. All I hear is the starter, engine is not attempting to start at all. A friend said it was starter motor clutch but the looked and found that the aux belt is turning so probably not the starter.

Need help and possibly someone to fix it.

Thank in advance.

If your engine is spinning, then the starter is doing what it's supposed to do - turn the engine  :y
What about the pedal trick & see if there any codes .... 19 sounds as though it could be a likely candidate.  :-/  :-/
Logged

Elite Pete

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Chester
  • Posts: 19580
  • My spider senses are tingling
    • Audi SQ5 GSX1400
    • View Profile
Re: Urgent help needed! Won't start
« Reply #2 on: 24 October 2010, 10:38:30 »
As Andy says, see if there are any codes stored  ;)
Logged
Retired

feeutfo

  • Guest
Re: Urgent help needed! Won't start
« Reply #3 on: 24 October 2010, 10:41:20 »
Agree with mr B, pedal trick for fault codes, obd 2 code for crank sensor on your car is 0335 iirc, 19 is for the non drive by wire cars...

http://www.omegaowners.com/forum/YaBB.pl?num=1189022687
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39729
    • ML350 TDM SmartRoadster
    • View Profile
Re: Urgent help needed! Won't start
« Reply #4 on: 24 October 2010, 10:42:54 »
Quote
Agree with mr B, pedal trick for fault codes, obd 2 code for crank sensor on your car is 0335 iirc, 19 is for the non drive by wire cars...

http://www.omegaowners.com/forum/YaBB.pl?num=1189022687

Ah! I didn't know that!  :y  :y  :y
Logged

feeutfo

  • Guest
Re: Urgent help needed! Won't start
« Reply #5 on: 24 October 2010, 10:45:50 »
Yes tis 0335

http://www.omegaowners.com/forum/YaBB.pl?num=1220619694

So you may well see 10 flashes, 3 flashes, 3flashes, 5 flashes. From the car spanner light.  :y
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39729
    • ML350 TDM SmartRoadster
    • View Profile
Re: Urgent help needed! Won't start
« Reply #6 on: 24 October 2010, 10:46:02 »
Quote
....
and went to start it last night and it won't start. All I hear is the starter, engine is not attempting to start at all. ....


Just had another thought .... I know I know!  ::)
How was it used the last time it started? When cars are started to just move a couple of feet, to allow another car of ther drive etc, and then switched off, you can easily end up with a flooded engine.
Try starting with wide open throttle.  :-/
Logged

richardirv

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Leeds, West Yorkshire
  • Posts: 1359
    • Omega 2.6 MV6 2002
    • View Profile
Re: Urgent help needed! Won't start
« Reply #7 on: 24 October 2010, 10:50:25 »
Well the code comes up 10 1 10 10. Which I assume is 0100. Which isn't really helpful
Logged

feeutfo

  • Guest
Re: Urgent help needed! Won't start
« Reply #8 on: 24 October 2010, 10:51:27 »
Quote
Quote
Agree with mr B, pedal trick for fault codes, obd 2 code for crank sensor on your car is 0335 iirc, 19 is for the non drive by wire cars...

http://www.omegaowners.com/forum/YaBB.pl?num=1189022687

Ah! I didn't know that!  :y  :y  :y
:y

Just been through this myself with another car, would not start...trouble with that one was it gave a hat full of codes from maf to 02 sensor and several others but no crank sensor code. Cleared the codes, tried to start and failed, pedal trick again and got 0335 alone so conclusive eventually  :-/
Logged

feeutfo

  • Guest
Re: Urgent help needed! Won't start
« Reply #9 on: 24 October 2010, 10:53:41 »
Quote
Well the code comes up 10 1 10 10. Which I assume is 0100. Which isn't really helpful
Ah, maf, unplug it and try again...
Logged

richardirv

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Leeds, West Yorkshire
  • Posts: 1359
    • Omega 2.6 MV6 2002
    • View Profile
Re: Urgent help needed! Won't start
« Reply #10 on: 24 October 2010, 10:56:31 »
Quote
Quote
Well the code comes up 10 1 10 10. Which I assume is 0100. Which isn't really helpful
Ah, maf, unplug it and try again...



Will try but do you really think it will be that simple?
Logged

feeutfo

  • Guest
Re: Urgent help needed! Won't start
« Reply #11 on: 24 October 2010, 11:00:13 »
Quote
Quote
Quote
Well the code comes up 10 1 10 10. Which I assume is 0100. Which isn't really helpful
Ah, maf, unplug it and try again...



Will try but do you really think it will be that simple?
No, but needs eliminating IMO.... :-/

If it's no different still suspect crank sensor.....
Logged

richardirv

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Leeds, West Yorkshire
  • Posts: 1359
    • Omega 2.6 MV6 2002
    • View Profile
Re: Urgent help needed! Won't start
« Reply #12 on: 24 October 2010, 11:00:58 »
Taking maf off didn't change anything.
Logged

feeutfo

  • Guest
Re: Urgent help needed! Won't start
« Reply #13 on: 24 October 2010, 11:06:37 »
Quote
Taking maf off didn't change anything.

Not maf then.
Crank sensor will often throw other codes, the ecu is fuddled as it does not have it's base reading from crank sensor IMO.

Ideally clear the codes and try again, needs a reader though...
Logged

richardirv

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Leeds, West Yorkshire
  • Posts: 1359
    • Omega 2.6 MV6 2002
    • View Profile
Re: Urgent help needed! Won't start
« Reply #14 on: 24 October 2010, 11:09:33 »
I don't have access to a reader unfortunatly, is there anything else I can try to help diagnose it?
Logged
Pages: [1] 2 3  All   Go Up
« previous next »
 

Page created in 0.017 seconds with 17 queries.