I`m actually half way through fitting cruise to my `99 (T reg.)....it began with my dip/turn signal stalk going belly-up so that the headlights wouldn`t stay on dip....so, as I`d read the 'how-to' in the forum maintenance guide I thought the stalk change would be the perfect excuse to get 'cruised'
The stalk (bought off forum member) is a 20 minute job to change.....and the 4 pin brake switch (new from Vx. £17.) a further 15 mins of work, cursing under the driver`s footwell.
Assuming your car is an auto you wont need a cruise clutch-pedal switch, if it`s manual-box then you will have to get one.
ALL the wiring is already in place....so it`s
plug-and-play.
The cruise actuator (also bought S/H off a forum member) is my next job to fit.....not tricky at all but will require some work-arounds as I have a secondary water circ. pump to remove/remount (also covered in the 'how-to').....The whole job could easily be completed in an afternoon....as far as I`m aware no need at all for Tech 2.
The later cars that are FBW; without a conventional throttle 'cable', do require only a cruise stalk to be bought/fitted (no cruise actuator reqd.) but do require Tech 2 enablement.
So, your first port of call is to read the
Cruise How To in the maintenance guide, then ask on the forum for the S/H bits needed and be sure to avoid the scrap yard that
TMX MV6 frequents!
Any probs. with the project Martin and the forum is always here to help.
Cruise How to: http://www.omegaowners.com/forum/YaBB.pl?num=1166374649
Author
Topic: hi all anyone can tell me about cruise control (Read 1209 times)